Skip to main content
Icom America Help Center home page Home

  • USA

  • icomamerica.com
  • Sign in
  • Sign in
  • Submit a request

Attention

Icom America's Technical Support Center website is intended to answer technical or operational questions on Icom products purchased in North America and South America.

If you purchased product outside these regions, please click on the button below to find and contact a local Icom distributor.

  1. Icom America
  2. Miscellaneous
  3. FAQ / Operational / Misc.

FAQ / Operational / Misc.

  • ICPW1: Pass-Through Serial Numbers What is the serial number cut-off for the older versions of the IC-PW1 that do not allow pass through operation?
  • HF Radio and PW1 Control Connections
  • Amateur: Poor Receiver sensitivity of my Icom FM mobile transceiver (such as IC2710H, IC207H, IC2100H, IC2350H).
  • Amateur Preamp: The receive preamp built into my IC820H, IC970A/H, IC821H, or IC910H all mode VHF/UHF satellite radio doesn't make any difference when I turn it on.
  • Amateur: HF base radio is about 800 Hz - 900 Hz off frequency.
  • Amateur HF: Won't transmit in CW mode.
  • Amateur General: The s-meter on my Icom all mode radio is stuck at an arbitrary level, and the receiver sensitivity is down.
  • Amateur Mobile: Internal vs External Antenna Tuner
  • Amateur Radios: USB or LSB voice signals are high pitched. AM and FM modes are OK.
  • Amateur: Display Distortion when I transmit, and/or bad TX audio, and/or carrier power in SSB modes without modulation
  • Amateur Handheld: Reception poor with external high gain antenna
  • Amateur Handheld: Battery voltage is ok, but radio shuts down.
  • Amateur Handheld: Battery Voltage Meter Incorrect
  • Amateur Handheld - PTT Beep: My Icom IC-2SRA, IC-4SRA or IC-W2A handheld radios won't transmit. I get beeps from the speaker when I key the PTT, and there is a "PL" symbol on the LCD display.
  • Receivers General: The s-meter on my Icom all mode receiver is stuck at some arbitrary level, and my receiver sensitivity is down in SSB and CW modes. I can't hear anything!
  • Receivers General: I have one of the Icom wide-band all mode base receivers. Only one frequency range seems to be receiving. All other bands are dead.
  • PCR100: Speaker audio seems very low.
  • IC746PRO: Features Tour
  • IC756Pro2 Technical Report
  • Avionics VOR: handheld navcom is not picking up VOR signals, unless I'm right on top of the VOR
  • M88: Accessing Land Mobile Channels
  • Marine VHF Interference Issue
  • Marine VHF: Can't talk to a close vessel.
  • Marine VHF Hailer Feedback Issue
  • Marine SSB Power Requirements: Can I use SSB radio on a vessel with a 24 Volt electrical system?
  • Marine Dimming Display Lights: The display lights dim when I transmit. The radio even shuts down by itself sometimes. I'm not getting full TX output power either.
  • FRS radios: In my area, there are many FRS radio users. Can I limit my reception so that I only hear calls that come in from my friends?
  • FRS: Is it legal to scramble my transmissions with an FRS radio?
  • A3 / A22: What is the difference between the IC-A3 / A22 and the IC-A3 / A22 Sport?
  • Avionics Handheld Reduced Range: The range of my Icom handheld radio seems reduced when I'm using it inside the cockpit. Why?
  • « First
  • ‹ Previous
  • Next ›
  • Last »
© 2025 Icom America Terms of Service Privacy Policy Support in Other Regions